iacopo ducci University of Florence

Hi,
how do I insert a series into a plot and represent it with points joined by lines? I can not change the type of plot; in Format, there are no point entries (Immagine), as appearing in previous projects (Immagine 2).. why?
Thanks
Iacopo

Hi,
I'm simulating an aerobic digestion with ASM1; I'm using a tradional ASU block; I read that the upper limit on SRT for validity of the model to single sludge systems is about 30 days; so, since my SRT is superior (40 days), what problems can I find?

thanks
iacopo

Ok, I try with a calculator variable.

Another question:  How is the "Aeration Energy" calculated by the software? and "Mixing Energy"?

Thanks
Iacopo

Hi,
How can I determine the oxygen transfer rate (OTR) under operating conditions in an ASU? There is the Kla measurement, but not the OTR.

Thank you
Iacopo

Hi,
how do I simulate a plug flow reactor for a tracer test? is there a PFR block in West 2016? or I can just use many CSTR reactors in series to simulate a PFR reactor.

Thanks
Iacopo

Hello,
in West 2016, I would like to create a graph of a cumulative curve, for example, I would like to know the total sludge obtained after X days; how do I create this variable?

thanks
iacopo

Thank you very much

Sorry,

I don't understand the sequence of the blocks. The cycle is: the aerator receive DO, V_ASU, SRT from the tank and return the kLa at the tank, right? How does PI controller receive DO measurement as input? From aerator or tank? And return (output signal 'u') Q_Air? What connects the output of controller?

Thank you for your availability

Looking more carefully I saw that there is a controller Aerator (that on Model Editor is called irvine_carbon_footprint). I think it might be useful to me. In a few words, given Q_air returns O2_tank, right? Could you tell me please more about how to use this block? Which variables I have to select on the links?

Thanks

Hi all,

I am new on this forum. I have a problem: I would need to set up a control (PI controller) on the aerobic tank that return as output DO imposing constant Kla and constant flow air. I currently have a control that, fixed setpoint DO, it calculate Kla such that it has setpoint DO; I noticed that on the link tank-control control you can choose several variables to y_M, while on the link control-tank only parameter u to Kla.

Essentially I would check that you have consumption of DO in the tank when the biodegradable load changes in input plant, with constant Kla and constant flow air. At present imposing a set point of DO, when I increase the input load, having to maintain set point DO, the model returns me an increase of Aeration Energy and so of flow air. I suppose I should create a new model in the library. but how?!

Thanks