Laura Wignall PhD Student

Hi Aurelian,

Thank you very much.

Laura

Hi,

I have very limited data for my model, including no data for the lower boundary condition so I want to define it as 'free outflow'. However, I cannot find an option to do this in MIKE 11. As far as I can see the only option in MIKE 11 for boundary conditions which doesn't require additional data is 'closed' which is not applicable here.

Any ideas would be appreciated.

Laura

Thank you for your help. I will take a closer look at my cross section data.

Laura

Hi,

I have exported the data for the cross sections in question.

Thanks in advance for any help.

Much appreciated.

Laura

Hi,

I am using MIKE 11 to create a model of the main branch of a river. I have imported my cross sections as raw data (X, Z) however when I run the simulation I get the following error:
ERROR: Processed hydraulic radii must be positive.
Cross section as reach 'MAIN BRANCH', chainage 2000.00 m.

I have looked at the processed data for this cross section and for the last two rows, the hydraulic radius has been calculated as 0- but I dont know why. I have attached a screen shot. Any guidance welcome.

Also, I dont have any data available for the lower boundary condition so was hoping to define as free outflow- what option in boundary data editor would this be?

Thanks.